Martha starts 08.11.15
Betsey resumes 09.01.29
** Beam 6.1 dead again; FAA radar OFF.
   Usual WAPP AGC datablock warning messages
 
** The drift is 25p1 +055742       
** This is a fall drift....
** The pos file name is therefore:    pos_081031_+055742f.sav
**
-- Working in:  /home/rutados/data/idl/work/proc/08.10.31
   cp /home/dorado13/galaxy/idlraw/08.10.31/*list* .
   gedit cal081031.list
   gedit drift081031.list
   >idl
   >@wasinit2
   >@alfinit

--  > callist='cal081031.list'        
   > dir='/home/dorado13/galaxy/idlraw/08.10.31' 
   > calib1,callist,dcalON,dcalOFF,dir=dir
   > help,dcalon,/st
   > calib2,dcalON,dcalOFF,ncalib
   > Any bad boards in system?
   y
   How many bad boards? [enter n]
: 2
Enter nbeam, npol of bad board
: 6,1
Enter nbeam, npol of bad board
: 7,1
   > help,ncalib,/st
   > save, ncalib,file='ncalib_081031.sav'    
** There are 17 cal values for this run ***
** Slight curvature; n=3. Looks fine.
** Dropped one low point (pt 4) from Beam 6.

--  bpdgui
   Set the list of files (upper left; use "browse"): drift081031.list.
   Enter the new calsession: calsession_081031.sav
   Enter the new runpos: pos_081031_+055742f.sav 
   set CRAT to "fit", not "median"
**The interp regions here are [3484 to 3524; give a check to M33 at 01h30; ok **
-- restore,'pos_081031_+055742f.sav'
   help,pos
** There are 17 drifts for this part of the run **

-- restore,'pos_081031_+055742f.sav'
-- restore,'        d214400+294831.526180333.sav'
-- flagbb,dred,cont_pt,mask,pos,GAUSAV=11,HAN=3,AGC=1,n1=0,n2=6
   at end, save badboxes to file
   filename = bb
   then save pos file in case of crash
   save,pos,file='pos_081031_+055742f.sav'
-------------------------------------------------------------------------------

  d000347+055743.830500172.sav  q1   1 AGC  pretty quiet; no FAA  burst ~1379 MHz most beams
  d001354+055743.830500174.sav  q1   nada   no burst this time.
  d002401+055743.830500176.sav  q1  0 AGC
  d003408+055743.830500178.sav  q1  1 AGC
  d005525+055743.830500181.sav  q1  0 AGC  cont source bm3,5
  d010531+055743.830500183.sav  q1  0 AGC
  d011538+055742.830500185.sav  q1  1 AGC
  d012546+055743.830500187.sav  q1  0 AGC + 1 nAGC
  d013552+055743.830500189.sav  q1  2 AGC
  d014559+055743.830500191.sav  q1  1 AGC  cont source bm5,0
  d015605+055743.830500193.sav  q1  1 AGC
  d020612+055743.830500195.sav  q1  2 AGC
  d021620+055742.830600002.sav  q1  0 AGC
  d022626+055743.830600004.sav  q1  1 AGC
  d023633+055742.830600006.sav  q1  1 AGC
  d024639+055742.830600008.sav  q1  3 AGC  + 2 nAGC  HVC
  d025646+055743.830600010.sav  q2  3 AGC  HVC; strong cont source bm2,6,1


** Be sure to save your pos file regularly!
   save,pos,file='pos_081031_+055742f.sav'
   
You can inspect the averaged, smoothed datasets for each beam using STRIP_PV and INSPECT
   strip_pv,dred,cont_pt,msmooth,n1=0,n2=6,showpol=3,gausav=11,han=5,rfimod=0,units=1
   inspect,msmooth,showpol=3,nstrip=4,agc=1

You can review your flagging using
   reviewbb,dred,cont_pt,mask,pos,GAUSAV=11,HAN=3,AGC=1,n1=0,n2=6

>   print,where(pos.badbox[0,0,0,2] eq 0)


This is a nice dataset with little RFI. FAA off!


**Non-AGC galaxies as follows:
**drfit	   beam  rec  chan  vel    optID?   optpos          comment
**d012546   0    478  2274  6457   good     0133465+055737  faint smudge
**d024639   5    410  2354  6018   prob.    0253555+055554  faint smudge
**d024639   1    306  2185  6922   ?        0251525+060312  far from nominal center