Martha starts 080613

** Beam 0 Pol B continues to fluctuate as in previous runs, 
** although power level stays mainly in acceptable range.
** Will have to keep an eye during calib especially.
 
** The drift is 15p2 +033900           {Be sure to note the declination!}
** This is a spring drift....
** The pos file name is therefore:    pos_080503_+033900s.sav
**
-- Working in:  /home/rutados/data/idl/work/08.05.03
   cp /home/dorado13/galaxy/idlraw/08.05.03/*list* .
   gedit cal080503.list   
   gedit drift080503.list 

   >idl
   >@wasinit2
   >@alfinit
-- Perform the calibration, in 2 steps:
   > callist='cal080503.list'               
   > dir='/home/dorado13/galaxy/idlraw/08.05.03/'
   > calib1,callist,dcalON,dcalOFF,dir=dir
   > help,dcalon,/st
   > calib2,dcalON,dcalOFF,ncalib
   > Any bad boards in system?
    "n" 
   > help,ncalib,/st
   > save, ncalib,file='ncalib_080503.sav'   
** There are 17 cal values for this run ***
** The calibration for this run looks fine. Notice nothing unusual
   about 0B. There are some GPS records.
-- Set up and run the BPD gui.
   > bpdgui
   Enter the new calsession: calsession_080503.sav
   Enter the new runpos: pos_080503_+033900s.sav 
   set CRAT to "fit", not "median"
**The interp regions here are [3485 to 3415]*
-- restore,'pos_080503_+033900s.sav'
   help,pos
** There are 17 drifts for this run **

*****Becky starts flagbb 080630

-- restore,'pos_080503_+033900s.sav'
-- restore,'d134331+033901.812400202.sav'
-- flagbb,dred,cont_pt,mask,pos,GAUSAV=11,HAN=3,AGC=1,n1=0,n2=6
   at end, save badboxes to file
   filename = bb
   then save pos file in case of crash
   save,pos,file='pos_080503_+033900s.sav'

--------------------------------------------------------------------------------  d134331+033901.812400202.sav  q1  1 AGC    FAA weak! 0.1 shows noise; STAT=2
  d135339+033901.812400204.sav  q2           GPS: rec 220-420  0.1 shows noise + sw; STAT=2, 2.0 has some intermods, cs: 6
  d140347+033900.812400206.sav  q1  2 AGC    0.1 shows noise; STAT=2
  d141353+033901.812400208.sav  q2           GPS: rec 545-599  0.1 shows noise; STAT=2, rec 473-599, sw: 1.1  
  d142400+033901.812500002.sav  q2  2 AGC    GPS: rec 0-44  .1 shows noise; STAT=2 intermods 2.0
  d143407+033901.812500004.sav  q1  1 AGC    cs: 0,2   0.1 better: STAT=1  
  d144413+033901.812500006.sav  q1  2 AGC    1.1 is a bit noisy
  d145420+033901.812500008.sav  q1  1 AGC
  d150428+033901.812500010.sav  q2           GPS: rec 357-455 set to STAT=5 fix status on 4.1, 5.1, 1.0
  d151436+033901.812500012.sav  q1           0.1 noiser; STAT=4
  d152443+033901.812500014.sav  q1           0.1 noiser + sw; STAT=4  intermods: 2.0   sw: 0.1, 1.1
  d153450+033901.812500016.sav  q1  2 AGC    0.1 better: STAT=1 
  d154456+033901.812500018.sav  q1
  d155503+033901.812500020.sav  q1  
  d160511+033900.812500022.sav  q1   
  d161518+033901.812500024.sav  q1           0.1 noise+sw; STAT=2 , intermods: 2.0  cs: 1
  d162524+033901.812500026.sav  q1           cs: 1


   strip_pv,dred,cont_pt,msmooth,n1=0,n2=6,showpol=3,gausav=11,han=5,rfimod=0,units=1
   inspect,msmooth,showpol=3,nstrip=4,agc=1


>   print,where(pos.badbox[0,0,0,2] eq 0)
 OK

** Overall good data, except for bm 0.1 noise. Status reduced to 2 or 4 
** on several drifts. In d150428+033901 GPS is so strong as to mess up 
** full spectrum; these records reduced to status 5.

Of interest:
d144413   nice pair: A9579 & A9576 - extended HI + bridge?