Martha starts 08.06.26

** Beam 1B has low power level. Drop it. Otherwise ok.
   Late start due to WAPP failures
 
** The drift is 53p2 +125348          
** This is a fall drift....
** The pos file name is therefore:    pos_061108_+125348f.sav
**
-- Working in:  /home/rutados/data/idl/work/proc/06.11.08
   cp /home/toro1/galaxy/idlraw/06.11.08/*list* .
   gedit cal061108.list   
   gedit drift061108.list 

** I notice that both the cal list and the drift list contain a partial scan
** so I remove the erroneous stuff from both lists.

   >idl
   >@wasinit2
   >@alfinit

--  > callist='cal061108.list'        
   > dir='/home/toro1/galaxy/idlraw/06.11.08' 
   > calib1,callist,dcalON,dcalOFF,dir=dir
   > help,dcalon,/st
   > calib2,dcalON,dcalOFF,ncalib
   > Any bad boards in system?
   y
How many bad boards? [enter n]
: 1
Enter nbeam, npol of bad board
: 1,1
   > help,ncalib,/st
   > save, ncalib,file='ncalib_061108.sav'    
** There are 29 cal values for this run ***
** The calibration for this run looks ok; some curvature
   There is one point at AST 77202 which shows low Tsys and CalRat in most 
   beams; deleting this one. Watch out for this later.....

--  bpdgui
   Set the list of files (upper left; use "browse"): drift061108.list.
   Enter the new calsession: calsession_061108.sav
   Enter the new runpos: pos_061108_+125348f.sav 
   set CRAT to "fit", not "median"
**The interp regions here are [3485 to 3517] **
-- restore,'pos_061108_+125348f.sav'
   help,pos
** There are 29 drifts for this run **

MARTHA STOPS HERE AFTER FLAGGING 1st DRIFT (bb exists)

Manolis picks up from here and finishes


Next, start working on FLAGBB:


-- restore,'pos_061108_+125348f.sav'
-- restore,'d214400+294831.526180333.sav'
-- flagbb,dred,cont_pt,mask,pos,GAUSAV=11,HAN=3,AGC=1,n1=0,n2=6

--------------------------------------------------------------------------------

  d222001+125349.631270517.sav   q1    1 AGC   strong FAA, mods 1.0(s=2)
  d223007+125349.631271122.sav   q1
  d224014+125349.631271727.sav   q1
  d225021+125349.631272332.sav   q1    1? agc
  d230027+125349.631272937.sav   q1    1 agc
  d231034+125349.631273542.sav   q1    1 agc
  d232040+125349.631274147.sav   q1
  d233047+125349.631274752.sav   q1    2(3?) agc
  d234053+125349.631275357.sav   q1    1 agc
  d235060+125349.631275962.sav   q1
  d000106+125349.631276567.sav   q3    1 agc; strong cont. source; very noisy, mods 4.0,4.1,3.0,3.1,5.0,5.1(s=2)
  d001113+125349.631277172.sav   q2    2 agc; noisy 
  d002119+125349.631277777.sav   q2    1(2?) agc; GPS; somewhat noisy 
  d003126+125349.631278382.sav   q2    strong GPS; noisy
  d004132+125349.631278987.sav   q2    GPS; somewhat noisy
  d005139+125349.631279592.sav   q1    mods 4.0,4.1,3.0,3.1,5.0,5.1(s=2)   
  d010145+125349.631280197.sav   q1    somewhat noisy
  d011152+125349.631280802.sav   q2    1 agc; 4.0 baseline not flat
  d012158+125349.631281407.sav   q2    1 (big spiral!) agc;4.0,4.1,3.0,3.1 noisy
  d013205+125349.631282012.sav   q2
  d014211+125349.631282617.sav   q2/q1
  d015218+125349.631283222.sav   q2
  d020225+125348.631283827.sav   q2
  d021231+125349.631284432.sav   q1
  d022238+125349.631285037.sav   q1
  d023244+125349.631285642.sav   q1
  d024251+125349.631286247.sav   q2     1 (interacting pair!) agc (and 1 globular cluster!)
  d025257+125349.631300452.sav   q1     3 (1 big barred, 1 big spiral!)
  d030304+125348.631301057.sav   q1


   save,pos,file='pos_061108_+125348f.sav'
   
   strip_pv,dred,cont_pt,msmooth,n1=0,n2=6,showpol=3,gausav=11,han=5,rfimod=0,units=1
   inspect,msmooth,showpol=3,nstrip=4,agc=1
   reviewbb,dred,cont_pt,mask,pos,GAUSAV=11,HAN=3,AGC=1,n1=0,n2=6

>   print,where(pos.badbox[0,0,0,2] eq 0)


** Drift q1 in the first half, but q2 (rfi and non-flat baselines) in the second half;
    Beam 1.1 dead. Beam 4.0 always noisy (sometimes 4.1,3.0,3.1 
    noisy). Beam 1.0 not perfect but well-behaved **